It also bites into the wood and gives a solid fixing, that is harder to pull out than a nail. This allows the screw to really pull the plasterboard tight to the timber. The first way they are superior is their coarse thread. Screws give better fixingsĭue to their design, screws give a better fixing in a couple of different ways. Obviously, if you have access to props, or even a board lift, this does change things slightly, but we can still go back to speed, where screws are far superior. In contrast, this would be much easier with screws, or a screw gun. However, when it comes to boarding a ceiling, it is far more complicated when you are trying to nail.Įven fitting smaller boards it would be quite difficult for one person to fix to a ceiling with nails. If you are fixing plasterboards to stud work, then depending on experience, screwing is only slightly easier. We already discussed how easy it is to use a screw gun, but even a cordless drill is easier than hammering nails. You can see a great example of a good quality screw gun by clicking here Installing with screws is easier than nails As opposed to manually nailing 15-20 individual nails.Īlso, screw guns aren’t that expensive, especially if you’re doing a lot of boarding. This means fixing an entire board will take 1-2 minutes. All you need to do to fix them, is apply pressure and push the trigger.Īfter a small amount of practice, you should be fixing screws at the perfect depth, without any misfires or jams in the gun. The screws are loaded into the gun in a plastic strip. Using a screw gun is a game changer, it will allow you to fix boards extremely quickly, with very little hassle. However, even then, it is likely they can’t go as fast as someone experienced at fitting with screws.Īlso, if the person screwing is using collated screws and a screw gun, the person nailing has no chance. Over the years, they have developed considerable skill and speed when it comes to nailing boards. You will still find older guys on site, who learnt to nail boards as an apprentice. Unless you are an older, more experienced plasterer, who learnt to fix plasterboard with nails, it is going to take you far longer nailing than screwing. 5 Reasons screws are better than nails for fitting plasterboardīelow you can see a few of the main reasons that drywall screws are a better option than clout nails: Screwing is faster However, in most cases, this is a false economy, as it will take you far longer than screwing. I wanted a happy place to put plants in my office.Another reason someone might choose nails, is because they are cheaper than screws. Gold foil map / rainbow wall hanging / pink letter board Ready to see how my office shelves turned out?! office shelves So make sure to measure twice and drill once! Use a drill to create a pilot hole with a drill bit before inserting the anchor. I used these anchors/screws and they worked wonderfully! The down side of this option is that you’ll be putting a big hole in the plaster. anchors for plaster wallsįor the next option, you can use an anchor and screw designed for plaster. Either of these will help you find a stud so you can use a screw into the stud for hanging heavy things in plaster. I’ve also heard great things about Studpop2 since the magnet pops out when you get to a stud. I used the Stud Buddy and it was perfect for what I needed. This worked GREAT for me- even with the paneling over the lath and plaster (which I was worried would make it too think for the magnet to work). But, using a stud finder that is magnetic works like a charm since it sticks to the nails in the lath that are connected to the studs. Sadly, a traditional stud finder won’t work with plaster since it will just detect the lath, not the studs. If you’re going heavier, you’ll need special tools. Since my plaster is covered in paneling, that’s what I’ve done so far. If you’re going to hang something light in plaster, you can use a small screw or nail and it should be fine. So installing or using a picture rail is an option! Thus eliminating the need for making any holes in the walls. You then connect wires to the picture rail from a hook and hang the art from the wire. This is a piece of trim that is attached to the studs higher up on the wall. Traditionally, homes with plaster walls had a picture rail. A post shared by Jenny Komenda on at 8:14am PDT
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |